WCB stainless steel gear pump

The WCB stainless steel gear pump belongs to the low pressure micro portable energy-saving oil transfer pump, which is more suitable for selling unit oil drums without power supply to convert oil. It is also suitable for oil transportation in refineries, power plants, substations, and oil depots, and for treating thin oil in lubrication systems. For example, when transporting non lubricating oil, beverages, low corrosive water, etc., please choose an integral stainless steel gear pump.

The WCB stainless steel gear pump can transport clean neutral oils with a viscosity of 1-8 ° E (such as engine oil, kerosene, diesel, and various vegetable oils) from one container to another. It can improve work efficiency and reduce labor intensity, making it suitable for oil transportation in industries such as commerce, industry, and agriculture.

Installation of WCB stainless steel gear pump:

1. Before installation, check whether the pump has been damaged during transportation, such as whether the motor is damp, whether the dust covers at the inlet and outlet of the pump are damaged, and whether there is any dirt entering the pump chamber.

Before installing the pipeline, the inner wall of the pipeline should be cleaned with clean water or steam. It should be avoided that the weight of the pipeline is borne by the pump, which affects the operation and accuracy of the pump.

3. Each connection part of the pipeline must not have any air or liquid leakage, otherwise it will not be able to absorb liquid and produce noise.

4. A metal filter should be installed at the suction port to prevent impurities such as particles from entering the pump.

Inspection before starting the pump

1. Are the fasteners of the pump tightened.

2. Whether the driving shaft rotates flexibly.

3. Whether the valves of the inlet and outlet pipelines are open.

4. Whether the rotation direction of the pump meets the requirements (if viewed from the pump end towards the motor, counterclockwise main rotation is positive).

Maintenance during pump operation

The pressure of the pump and the reading of the vacuum gauge should comply with the technical specifications specified for the pump.

2. Pay attention to the working condition of the packing seal. If there is oil leakage, the pressure cap can be adjusted according to the degree (it is not allowed to press the pressure cap too tightly to avoid heating at the packing and wear of the sealing ring).

When there is abnormal noise or high temperature rise during the operation of the pump, the pump should be stopped immediately for inspection.

Stopping pump operation

1. Cut off the power supply.

2. Close the valve of the oil outlet pipeline.

Technical parameters: